Mechanical watch errors faster and faster watch the life of the wearer and the proper use and maintenance of watches faster and faster mechanical watches, watch the appearance of dirty mechanical watches faster and faster, the strap length does not apply to mechanical watches faster and faster, The use of harsh environment, are likely to lead to damage to the , shorten the service life. Time is not enough precision, the complex performance of the mechanical watch adjustment, there are some must comply with the way, should General Manager stressed that each of the complex performance of mechanical watches will be sold with operational instructions, even the movement of the table share models , But also because the watch factory to stop modification, showing the different parts of the configuration, the operation must pay special attention to the order, therefore, read the operation that is the top priority. If you really bother, you need to pay special attention to the correct use of fast-dial button, when you activate the fast-dial performance, you must adjust the clock to the correct location, it will not form a performance part of the card into the correct position, but was forced beating The quick-push button turns the problem causing the malfunction of the part. In the high-end watches every two to three years should be the appropriate maintenance, detection of travel time performance and movement power consumption, regular maintenance services will effectively extend the use of your watch time. why would you say so? As mechanical watches change from time to time, in a winding of the elastic state, fixed position, and temperature environment, it can be temporary accuracy, relative to another situation will change. The gap between the hour hand and the dial becomes smaller: the interval between the hour hand and the dial is the closest, if there is no safe gap, it will rub to the disk, to the dial to form arc-shaped scratches, which also includes the clock above the night out, Will be rub off the automatic mechanical watch does not go. In addition, the clock position is too low, rub to the LOGO logo on the dial, the sub-needle position is too low or sub-axle tilt, leading to the front of the minute hand rubbing to the dial when the above character. This will not only form scratches, but also to bring the to go wrong. In other words, even if the watch is corrected one second is not bad, it will not stick to it, the accuracy is always in the instantaneous and wavering in the change. Moreover, the accuracy of the watch there are many other elements of mechanical watches faster and faster, we see the watch is a real error and the unit time to go within the uniform error. Watches in full-winding state of the clock when the best precision To make my accurate travel time, we must take full winding as far as possible, which is more important from the watch. When the watch was violently shaken, the pointer may be scattered, especially the possibility of the second hand is greater. If the second hand (including a small second hand or other functions of the pointer) has fallen down, may be stuck in the hour and minute hands and dial, then continue to move the watch, then the second hand will be struck and scratched the dial face plate, thus forming Scratches on the dial. Of course, this time also assume that the dial needle, that situation is even worse, to know, the value of the dial is very high, and some accessories are not easy to find. As a result of self-winding watch the winding level and wear time, wear a direct relationship between movement, provided that the need to ensure that there is a sufficient amount of exercise.